I have seen a few different ways on different web sites. After finding a 54r berdan that had a crack near the base, I decided it was time to try it. The method that I used was listed on castboolits.

http://castboolits.gunloads.com/show...ckets-to-Boxer

The first thing I did was took a scrap 2x4 and drilled a hole to put the brass in primer up to hold it when drilling. Other than that, I did it right from the directions. I think all was good. Now I just need to try it out on a good case.

So, have any of you tried this or something like it? what kind of results did you have?