norma 9 MM

[don3]

Is there a issue with reloading NORMA 9 MM brass? I though I saw some where there was but can't remember where or what the issue was?
Thanks

Don

[Happyguy]

I believe that the primer hole is smaller then the normal decapping pin diameter. I enlarge the hole with the old primer still in the case.

[lightman]

The ones I have had lately had small flash holes. My Lee depriming die pushed them out with no problem but it made kind of a reverse burr in the primer pocket. I just hit the pockets with my uniforming tool and loaded them as normal. Other than the extra step its good brass.

[don3]

Thank you guys, I will keep an eye out for them, sounds like it would slow down my loading, I'm using a Dillon SD