PDA

View Full Version : 30 06 to .308 brass?



MJ1
08-11-2013, 09:12 AM
Anyone done this or seen a tutorial on utube? I have a load of 50s LC Match I want to cut down. There must be a start point for cutting off the case.

TIA

..MJ..

Taylor3006
08-11-2013, 10:43 AM
It can be done, dunno bout YouTube videos on the subject. It's a bit of work though and the necks on cut downs tend to be pretty thick. Personally I think it's a better idea to trade what you have for good 308 brass.

jebsca
08-11-2013, 10:45 AM
You can check here:

http://castboolits.gunloads.com/showthread.php?88389-30-06-to-308

If you look around, you can find info on reforming brass about any way you like. I had found a page that had someone that talked about getting more complex and changing the head or adding brass to the end to lengthen the case. Good luck.

jebsca
08-11-2013, 11:06 AM
I was able to find the page that I was talking about before.

http://www.castpics.net/subsite/Conversions/Case%20Reforming.pdf

This guy talks about some very extreme reforming. Most of what he is talking about would be more than you or I am looking to do, but he shows you how to plan it out in small steps and make it work.

MJ1
08-12-2013, 08:26 AM
Thanks. I just need a close cut off length I have reamers and some back ground. I will read the pages because you can never know everything or pass up good information.

Cheers and Pura Vida

http://img.photobucket.com/albums/v130/montereyjack/Costa%20Rica/218484f2.jpg (http://smg.photobucket.com/user/montereyjack/media/Costa%20Rica/218484f2.jpg.html)

Wizwheel
08-12-2013, 12:13 PM
It is easier to trade for what you need, I have 30-06 RP, WW, Fed, Mil / 308win. RP, WIN

Want - 45acp, 38 super/38auto/38acp, 303 british, 7.62x54r
mj